Gledhill Appliance Repair in St Loyes

What does error code 30 mean on a Gledhill A-Class system?

Error code 30 on Gledhill A-Class systems indicates a phase error with the electrical supply. Isolate the appliance from the electrical supply immediately. Do not attempt to check electrical connections yourself. Contact a qualified electrician or heating engineer to investigate the electrical supply, polarity, and voltage stability.

What does error code 51 mean on a Gledhill A-Class system?

Error code 51 on Gledhill A-Class systems indicates the S6 temperature sensor (store middle) has a short circuit. Turn off the system and isolate from the electrical supply. Check sensor wiring and connections. If intact, the sensor requires replacement. Contact a qualified heating engineer to fit a genuine Gledhill replacement sensor.

What does error code 43 mean on a Gledhill A-Class system?

Error code 43 on Gledhill A-Class systems indicates the S6 temperature sensor (store middle) has an open circuit. Turn off the system and isolate from the electrical supply. Inspect sensor wiring for damage. If wiring appears intact, the sensor is likely faulty. Contact a qualified heating engineer to replace with a Gledhill-approved sensor.

What does a fast flashing red light mean on a Gledhill PulsaCoil A-Class?

A fast flashing red light (four times per second) on Gledhill PulsaCoil A-Class indicates the control board has detected a potential overheat. Turn off and isolate the appliance from the electrical supply immediately. This can indicate actual overheating or a faulty control board. If you smell burning, evacuate and contact emergency services. Otherwise, contact a qualified heating engineer to diagnose the issue.

What does error code 37 mean on a Gledhill A-Class system?

Error code 37 on Gledhill A-Class systems indicates the S1 overheat sensor has an open circuit fault. Turn off the system and isolate from the electrical supply. Check the sensor connections at the controller. If secure, the overheat sensor requires replacement. Contact a qualified heating engineer to fit a Gledhill-approved replacement.

Where can I find the serial number on my Gledhill cylinder?

The 12-digit serial number for unvented cylinders and thermal stores is printed underneath the bar code on the data label or information badge located on the appliance. The first and last digits are spaced slightly away from the rest of the number.

How often should I check the header tank on my Gledhill thermal store?

Gledhill advises checking the header tank water level every three months. The tank should be filled with clean cold water to approximately halfway. Do not overfill as this can cause problems. Ensure the lid is securely replaced to reduce water loss through evaporation. Some units have an optional sight glass fitted to make checking the level easier.

How does the Economy 7 system work with my Gledhill PulsaCoil?

Economy 7 provides electricity at about half the normal price during the seven hours between midnight and 7am. Your PulsaCoil heats a full tank of water overnight using this low-cost electricity to last you throughout the day.

What is the minimum water pressure required for a Gledhill StainlessLite Plus?

For optimum performance, 3 bar pressure and a flow rate of 30 litres per minute is recommended. The appliance will work with lower pressures, however performance will decrease with low flow rate and low pressure.

What should I do with my Gledhill thermal store when going on holiday?

For absences under 2-3 weeks, keep all power switches on. For longer trips of 3 weeks or more, turn off the off-peak supply but maintain main power to exercise the pump regularly.