Whirlpool Appliance Repair in Exwick

What does the E4 error mean on a Whirlpool fridge freezer?

The E4 error on a Whirlpool fridge freezer indicates a fridge defrost sensor fault. The compartment temperature in the fridge may be incorrect due to a defrost cycle problem. Unplug the appliance from the mains before any inspection. Contact a qualified engineer to diagnose and repair the defrost sensor.

What does the F15 error mean on a Whirlpool washing machine?

The F15 error on a Whirlpool washing machine indicates a heater control fault where the machine is not heating water or pauses during the wash cycle. Unplug the appliance from the mains and contact a qualified engineer for professional diagnosis of the heater control system.

What does the F02 error mean on a Whirlpool dishwasher?

The F02 error on a Whirlpool dishwasher indicates a water fill solenoid valve failure. The inlet valve is not operating correctly. Unplug the appliance from the mains before any inspection. Contact a qualified engineer as the valve may need replacing.

What does the F12 error mean on a Whirlpool washing machine?

The F12 error on a Whirlpool washing machine indicates an electronic control fault where the machine is not turning on. Unplug the appliance from the mains and contact a qualified engineer as the control board may need to be replaced.

What does the F04 error mean on a Whirlpool dishwasher?

The F04 error on a Whirlpool dishwasher indicates a thermostat fault. The temperature control system is not functioning correctly. Unplug the appliance from the mains before any inspection. Contact a qualified engineer to diagnose and repair the thermostat.

Why is my Whirlpool washing machine leaking water?

Water leaks from a Whirlpool washing machine are often caused by a blocked or incorrectly positioned drain hose, a damaged door seal, or using too much detergent which creates excess suds. Check the door seal for tears or debris and ensure the drain hose is secure.

How do I clean the condenser on my Whirlpool condenser dryer?

Always unplug the dryer before cleaning the condenser. The condenser should be cleaned every month or after approximately 30 drying cycles. Remove the condenser unit from the bottom front of the dryer, rinse it under running water to remove fluff and debris, allow it to dry completely, and reinsert it.

Why is my Whirlpool washing machine not draining?

If your Whirlpool washing machine is not draining, check the drain filter for blockages. The filter is usually located at the front bottom of the machine. Also check that the drain hose is not kinked or blocked, and ensure it is positioned at the correct height.

How do I use the self-cleaning function on my Whirlpool oven?

Remove all racks and accessories before running the pyrolytic self-cleaning cycle. The oven heats to very high temperatures to burn off residue. The exterior becomes extremely hot during the cycle - keep children and pets away and ensure good ventilation. The cycle takes 2-3 hours and the door remains locked until the oven cools. Wipe away ash with a damp cloth once completely cool.

Why is my Whirlpool fridge ice maker not making ice?

If your Whirlpool ice maker is not producing ice, check that it is switched on and the water supply is connected. Ensure the freezer temperature is set to -18°C or below. Check that the ice bin is not full, as the ice maker stops when the bin reaches capacity. Allow 24 hours after installation for ice production to begin.