Remeha Appliance Repair in Newtown and St Leonard's

What does the error E[01 mean on a Remeha Quinta Pro boiler?

Error E[01 on a Remeha Quinta Pro boiler indicates the safety parameters are incorrect. Check wiring connections and reset the boiler. Contact a commercial heating engineer to reprogram safety parameters or replace the PSU if needed.

What does the error E04.20 mean on a Remeha Quinta Ace boiler?

Error E04.20 on a Remeha Quinta Ace boiler indicates a mass flow sensor deviation where the sensor reading is inconsistent. Contact a commercial heating engineer to check and replace the mass flow sensor if required.

What does the error E3 mean on a Remeha boiler?

Error E3 on a Remeha boiler indicates a control unit or earth fault. This could be dangerous. Check that the power supply is properly earthed. If earthing is correct, the control unit is faulty and requires replacement by a Gas Safe registered engineer.

What does the error E[00 mean on a Remeha Quinta Pro boiler?

Error E[00 on a Remeha Quinta Pro boiler indicates a parameter was not found in the storage unit. Check wiring connections. If the error persists, the PSU may need replacement. Contact a commercial heating engineer experienced with Quinta Pro systems.

What does the error E45 mean on a Remeha boiler?

Error E45 on a Remeha boiler indicates the boiler has reverted to default parameters, often due to a faulty control unit. The control unit typically requires replacement. Contact a Gas Safe registered engineer for diagnosis and repair.

What does it mean when my Remeha boiler displays an error code?

Remeha boilers display error codes (such as E0 to E45) to indicate specific faults. Common codes include E0 (sensor fault), E4 (ignition failure), E7 (no water or pump failure), and E8 (fan fault). Before resetting, accurately record the fault code including any figures, flashing digits, and dots.

What should I do if my Remeha boiler condensate pipe is frozen?

If your boiler stops working during cold weather and displays error E4 or similar codes, the condensate pipe may be frozen. Locate the frozen section of the white plastic pipe running outside and thaw it with warm water using a hot water bottle, microwaveable heat pack, or watering can with warm water. Once thawed, reset the boiler.

How often should I have my Remeha boiler serviced?

Remeha recommends having your boiler serviced annually by a Gas Safe registered engineer. For optimum service intervals for your specific application, refer to the product operation and maintenance manual.

How do I bleed radiators connected to my Remeha boiler?

First, open all radiator valves completely and set the room thermostat to its highest setting. Wait until radiators feel warm, then switch off the boiler. Allow approximately 10 minutes for the system to cool. Bleed the lowest radiator first by opening the bleed valve with a radiator key until air escapes, closing when water appears. Work progressively towards the highest radiator.

What are the installation requirements for a Remeha Quinta Ace?

The Remeha Quinta Ace must be installed in a frost-free area with minimum 1 metre by 1 metre clear space in front for standard maintenance. The condensate must be discharged via a tundish directly into a drain using synthetic materials rated for acidic condensate (pH 2 to 5) with minimum 30 mm per metre slope.