Remeha Appliance Repair in St David's

What does the error E04.14 mean on a Remeha Quinta Ace boiler?

Error E04.14 on a Remeha Quinta Ace boiler indicates the burner temperature and burner setpoint differ more than the parameter allows. Contact a commercial heating engineer to diagnose the gas valve and temperature sensors.

What does the error E04.12 mean on a Remeha Quinta Ace boiler?

Error E04.12 on a Remeha Quinta Ace boiler indicates a false flame was detected before burner start. This is a potentially dangerous condition. Do not attempt any repairs. Contact a commercial heating engineer immediately to check the ionisation electrode and gas valve operation.

What does the error E6 mean on a Remeha boiler?

Error E6 on a Remeha boiler indicates unwanted flame formation when no flame should be present. This typically means the control unit is faulty and requires replacement. Contact a Gas Safe registered engineer for diagnosis and repair.

What does the error E0 mean on a Remeha boiler?

Error E0 on a Remeha boiler indicates a flow or return sensor fault. The sensor is faulty, not connected properly, or has a short circuit. Check system pressure and repressurise if needed. Contact a Gas Safe registered engineer to test the sensor resistance and replace if faulty.

What does the error E10 mean on a Remeha boiler?

Error E10 on a Remeha boiler indicates no through flow during the venting cycle. Check and repressurise if pressure is low. Bleed radiators thoroughly to remove air. Verify the pump is operating. Contact a heating engineer if the error persists.

How do I set my Remeha boiler for holiday or extended absence?

For extended absences, the iSense controller allows you to programme shutdown periods during which the heating system operates in frost protection mode only. Access this through the programme menu. If your home will be unoccupied for a long period with risk of frost, you may alternatively drain the boiler and central heating system completely. Consult a qualified engineer if you are unsure which option is appropriate.

How do I adjust the temperature on my Remeha boiler?

For boilers with an iSense thermostat, press the Settings button and navigate to the Temperature section. Use the arrow buttons or turn the push-turn button to increase or decrease the desired temperature. The iSense uses a menu-controlled system with three buttons, making it simple to operate.

How do I reset my Remeha boiler?

To reset a Remeha boiler, locate the reset button marked with 'R' on the front panel. Press and hold the reset button for approximately 3 seconds until the boiler restarts. Wait 2 to 3 minutes for the boiler to fire up. If the first attempt fails, you may repeat twice more. If the boiler still fails to fire after the third attempt, check the gas supply.

Can Remeha Quinta Ace boilers be cascaded?

Yes, the Remeha Quinta Ace is ideally suited for cascade systems. A maximum of four appliances can be cascaded directly from appliance to appliance using quick-connect plug-and-play connectors. The compact boiler dimensions enable rapid installation and flexible siting.

What is included in a Remeha boiler service?

A Remeha boiler service typically includes checking the flue pipes and air supply pipes for leaks, checking the condensate siphon, checking hydraulic pressure, measuring ionisation current, inspecting flue gas connections, and cleaning the heat exchanger and plate exchanger if required.