Immergas Appliance Repair in Pennsylvania

What does the 23 error mean on an Immergas boiler?

The 23 error on an Immergas boiler indicates a return temperature probe anomaly. The NTC temperature sensor measuring return water temperature is reporting incorrect readings or has failed. Switch off the boiler at the electrical supply. Wait 30 seconds and switch back on to reset. If the error persists, contact a qualified technician for probe testing and replacement. This sensor is important for efficient boiler operation and protection against overheating.

What does the 29 error mean on an Immergas boiler?

The 29 error on an Immergas boiler indicates a flue temperature probe anomaly. The sensor measuring flue gas temperature is reporting incorrect readings or has failed. Switch off the boiler at the electrical supply. Wait 30 seconds and switch back on to reset. If the error persists, contact a qualified technician for probe testing and replacement. This sensor is critical for combustion safety monitoring.

What does the 231 error mean on an Immergas heat pump?

The 231 error on an Immergas heat pump indicates a condensation temperature sensor malfunction. The sensor monitoring refrigerant condensation temperature has failed or is reporting incorrect values. Switch off the heat pump at the isolator switch. Contact a qualified technician with F-Gas certification for diagnosis. This sensor is critical for efficient heat pump operation and refrigerant circuit protection.

What does the 202 error mean on an Immergas heat pump?

The 202 error on an Immergas heat pump indicates a sustained communication error between the control kit and outdoor unit lasting more than three minutes. Switch off the heat pump at the isolator switch for five minutes. Switch back on and monitor for the error. If communication is not restored, contact a qualified technician. Do not repeatedly reset the unit as this will not resolve a wiring or component fault.

What does the 425 error mean on an Immergas heat pump?

The 425 error on an Immergas heat pump indicates a supply voltage phase loss. This error applies only to three-phase models and indicates one of the electrical supply phases has been lost. Switch off the heat pump at the isolator switch immediately. Do not attempt to restart. Contact a qualified electrician to check the three-phase electrical supply. Operating with a missing phase can cause serious damage to the compressor motor.

How do I repressurise my Immergas boiler?

Locate the filling loop beneath or near your boiler. Open both valves slowly to allow cold mains water into the system while watching the pressure gauge. When it reaches between 1.0 and 1.2 bar, close both valves securely.

How does the defrost function work on my Immergas heat pump?

The heat pump automatically enters defrost mode when ice builds up on the outdoor unit's evaporator coil. During defrosting, the system reverses briefly to melt the ice, then returns to normal operation.

What should I do if my Immergas heat pump outdoor unit is making unusual noises?

Some noise during operation is normal, particularly during defrost cycles when the reversing valve operates. However, unusual grinding, rattling, or continuous loud noises may indicate a fault requiring professional attention.

What annual maintenance does my Immergas boiler require?

Annual maintenance should include cleaning the heat exchanger on the fume side, cleaning the main burner, verifying correct ignition and operation, and checking burner settings for both heating and hot water phases. A visual inspection for leaks and corrosion is also required.

Why are some radiators not heating up when my Immergas boiler is running?

If some radiators remain cold while the boiler is running, trapped air may be the cause. Bleed each cold radiator using a radiator key by opening the bleed valve until water flows steadily, then close it. Ensure all radiator valves are open. Check that the system pressure is between 1.0 and 1.5 bar after bleeding. If radiators remain cold after bleeding, or if multiple radiators are affected, contact a qualified technician as there may be a circulation pump fault or system blockage.