Faber Appliance Repair in Exwick

What does a steady LED light mean on a Faber cooker hood?

A steady LED light on a Faber cooker hood indicates that the metal grease filters need cleaning. This alarm activates after approximately 100 hours of operation. Remove the filters and wash them by hand or in the dishwasher, then reset the alarm by pressing and holding the reset button for 3-4 seconds until the LEDs flash three times.

What does a flashing LED light mean on a Faber cooker hood?

A flashing LED light on a Faber cooker hood signals that the activated charcoal filter needs replacing. This alarm appears after approximately 200 hours of operation in recirculation mode. Replace the charcoal filter with a genuine Faber replacement and clean the grease filters, then reset the alarm according to your model's instructions.

What does a single LED flash mean on a Faber cooker hood?

A single LED flash on a Faber cooker hood indicates that the remote control receiver has been deactivated. To reactivate the remote control, press the same button for approximately 5 seconds until the LED flashes twice to confirm activation.

Why does my Faber cooker hood turn on briefly every hour?

If your Faber cooker hood activates for approximately 10 minutes every hour, the 24-hour air circulation mode is enabled. This eco-friendly feature maintains fresh air in your kitchen by periodically ventilating at low speed throughout the day. To deactivate this mode, press and hold the designated button for approximately 2 seconds with the motor and lights off. Consult your instruction manual for model-specific controls.

What does it mean when the LED flashes twice on a Faber cooker hood?

Two LED flashes on a Faber cooker hood can indicate either that the remote control receiver has been activated, or that the activated charcoal filter alarm has been enabled. This is a confirmation signal showing the hood has registered your command.

Where should the ducting from my Faber cooker hood terminate?

Ducting must terminate outside of your home. A crawl space, attic, basement, or garage does not meet the definition of outside and should not be used as a termination point for the ducting.

What is the minimum installation height for a Faber cooker hood above an electric or induction hob?

The minimum distance between the cooker hood and an electric or induction hob is 65cm. If the hob has a larger cooking area, the hood may need to be positioned slightly higher to provide complete coverage.

Why is a ducted cooker hood quieter than a recirculating one?

Ducted hoods are quieter because the extracted air passes directly through the ducting without obstruction. In recirculating hoods, the air must pass through charcoal filters in addition to grease filters, creating extra resistance that increases noise levels. This additional filtration step is why recirculating hoods tend to be louder.

Why is my Faber cooker hood remote control not working?

First check whether the batteries need replacing and install fresh CR2032 batteries if necessary. If this does not solve the problem, the remote control receiver on the hood may be deactivated and needs to be reactivated through the hood's control panel.

Why is my Faber cooker hood noisy?

Noise is generated by the airflow passing through the grease filters during operation. Common causes of increased noise include dirty or clogged filters, undersized ducting, or obstructions in the duct run. Clean or replace filters regularly and ensure ducting is the correct diameter throughout the entire run.