Faber Appliance Repair in St David's

Why is my Faber cooker hood motor humming but not spinning?

If your Faber cooker hood motor hums but the fan does not spin, this typically indicates a faulty start capacitor or a seized motor. Switch off the hood at the mains immediately and do not continue using it in this condition. Symptoms may vary by model, so consult your instruction manual for model-specific guidance. Contact a qualified technician for diagnosis and repair.

Why is my Faber cooker hood not extracting properly?

Reduced extraction on a Faber cooker hood is usually caused by clogged filters, blocked ducting, or stuck damper flaps. Clean the grease filters thoroughly, replace charcoal filters for recirculation hoods, check the exterior vent for blockages, and ensure ducting is not kinked. If suction remains weak, contact a qualified technician.

Why are all LED buttons flashing twice on my Faber cooker hood?

When all LED buttons flash twice simultaneously on a Faber cooker hood, it indicates that the control lock mode has been activated or deactivated. This safety feature prevents accidental changes to hood settings during cleaning. To toggle the lock, press and hold the designated button according to your model's instructions. This is a confirmation signal, not an error.

Why is my Faber cooker hood making excessive noise or vibrating?

Excessive noise or vibration from a Faber cooker hood is commonly caused by incorrect installation, undersized ducting, or a loose mounting. Verify the hood is securely fixed and that ducting maintains the recommended diameter throughout the entire run without kinks or restrictions. Dirty filters can also increase noise levels. If vibrations persist after checking installation, contact a qualified technician as the motor or impeller may require inspection.

What does a flashing LED light mean on a Faber cooker hood?

A flashing LED light on a Faber cooker hood signals that the activated charcoal filter needs replacing. This alarm appears after approximately 200 hours of operation in recirculation mode. Replace the charcoal filter with a genuine Faber replacement and clean the grease filters, then reset the alarm according to your model's instructions.

What are the benefits of LED lighting in Faber cooker hoods?

LED lighting in Faber cooker hoods provides bright, even illumination across the entire cooking area while using significantly less energy than traditional halogen bulbs. LEDs also have a much longer lifespan and produce less heat, contributing to the overall energy efficiency of the hood.

How often should I clean the metal grease filters on my Faber cooker hood?

Metal grease filters should be washed every 2 months under normal cooking conditions (up to 3 hours of use per day). This equates to approximately every 100 hours of hood operation.

Are charcoal filters included with Faber cooker hoods?

Charcoal filters are not supplied as standard with most Faber cooker hoods because many models can be either ducted or recirculated. If you plan to use your hood in recirculation mode, you will need to purchase charcoal filters separately.

What duct diameter should I use for my Faber cooker hood?

For cooker hoods with an extraction rate of 300 m³/h or higher, a duct diameter of 150mm is optimal. Alternatively, 120mm ducting may be used. Always use smooth galvanized metal ducting and maintain the same diameter throughout the entire duct run for best performance.

Is grease on the filters a fire hazard?

Grease deposited on filters is inflammable, which is why regular maintenance is essential. Clean or replace filters according to the recommended schedule based on approximately 3 hours of daily use. Never allow excessive grease to accumulate on the filters.