Faber Appliance Repair in St Thomas

Why are the control panel buttons not responding on my Faber cooker hood?

Control panel buttons not responding on a Faber cooker hood may be caused by grease buildup, loose cable connections, or a faulty control board. Switch off at the mains, clean the control panel with a soft damp cloth, and leave unplugged for 10 minutes to reset. Symptoms may vary by model, so consult your instruction manual for model-specific guidance. If the issue persists, contact a qualified technician.

Why does my Faber cooker hood turn on briefly every hour?

If your Faber cooker hood activates for approximately 10 minutes every hour, the 24-hour air circulation mode is enabled. This eco-friendly feature maintains fresh air in your kitchen by periodically ventilating at low speed throughout the day. To deactivate this mode, press and hold the designated button for approximately 2 seconds with the motor and lights off. Consult your instruction manual for model-specific controls.

Why are all LEDs flashing three times on my Faber cooker hood?

When all LEDs flash three times simultaneously on a Faber cooker hood, it confirms that the filter saturation alarm has been successfully reset. This is a confirmation signal, not an error, and no action is required.

Why does my Faber cooker hood turn on by itself?

If your Faber cooker hood turns on automatically without manual activation, it is likely equipped with a heat sensor that detects high temperatures from your hob. This safety feature activates the extraction fan when excess heat builds up, helping to remove smoke and prevent overheating. Some models also feature K-Link technology that synchronises the hood with a compatible Faber induction hob, automatically adjusting extraction based on cooking intensity. This is normal operation for hoods with these features.

Why is my Faber cooker hood motor humming but not spinning?

If your Faber cooker hood motor hums but the fan does not spin, this typically indicates a faulty start capacitor or a seized motor. Switch off the hood at the mains immediately and do not continue using it in this condition. Symptoms may vary by model, so consult your instruction manual for model-specific guidance. Contact a qualified technician for diagnosis and repair.

How often should I deep clean the inside of my Faber cooker hood?

Deep clean the interior of your cooker hood and the duct inside the hood once a year. This includes cleaning all accessible internal surfaces where grease may have accumulated beyond the filters.

What type of battery does the Faber cooker hood remote control use?

Faber cooker hood remote controls use a CR2032 coin cell battery. When replacing the battery, ensure the new battery is installed with the correct polarity (+ and -).

What is the difference between ducted and recirculating Faber cooker hoods?

Ducted hoods expel cooking fumes directly outside through external venting, offering superior odour removal and quieter operation. Recirculating hoods filter the air through charcoal filters and return it to the kitchen, offering flexibility as they can be installed anywhere without external ducting.

What cleaning products should I avoid using on my Faber cooker hood?

Avoid using alcohol-based or silicone-based products to clean the inside or outside of your cooker hood, as these can damage the finish. Never use abrasive cleaners, scouring pads, or products containing chlorine. Use only mild soap with a soft cloth or sponge.

How do I find the model and serial number of my Faber cooker hood?

The model and serial number of your Faber cooker hood are printed on the label located inside the hood. To access this label, switch off the hood at the mains, then remove the grease filters to reveal the white identification label underneath.