Faber Appliance Repair in Newtown and St Leonard's

Why does my Faber cooker hood run at high speed for only 6 minutes?

When your Faber cooker hood runs at maximum speed and automatically reduces after 6 minutes, this indicates the intensive speed mode is functioning correctly. This timed feature provides maximum extraction power for heavy cooking tasks such as frying or grilling, then automatically returns to a lower speed to conserve energy. This is normal operation, not a fault.

Why are the lights not working on my Faber cooker hood?

If the lights on your Faber cooker hood do not illuminate but the motor works, it may be a bulb, LED strip, or driver failure. Switch off at the mains before any inspection. For halogen models, you may check and replace the bulb with a matching type, avoiding direct skin contact with the new bulb. For LED models, contact a qualified technician as LED components require technical expertise to replace. Consult your instruction manual for model-specific bulb specifications.

Why does my Faber cooker hood turn on by itself?

If your Faber cooker hood turns on automatically without manual activation, it is likely equipped with a heat sensor that detects high temperatures from your hob. This safety feature activates the extraction fan when excess heat builds up, helping to remove smoke and prevent overheating. Some models also feature K-Link technology that synchronises the hood with a compatible Faber induction hob, automatically adjusting extraction based on cooking intensity. This is normal operation for hoods with these features.

Why does my Faber cooker hood turn off automatically after 30 minutes?

If your Faber cooker hood switches off automatically after 30 minutes, the delay function is active. This feature allows the hood to continue extracting residual cooking odours after you finish cooking, then shuts off automatically. To deactivate this function, press and hold the delay button for approximately 3 seconds according to your model's instructions. This is a programmed feature, not a malfunction.

Why are the control panel buttons not responding on my Faber cooker hood?

Control panel buttons not responding on a Faber cooker hood may be caused by grease buildup, loose cable connections, or a faulty control board. Switch off at the mains, clean the control panel with a soft damp cloth, and leave unplugged for 10 minutes to reset. Symptoms may vary by model, so consult your instruction manual for model-specific guidance. If the issue persists, contact a qualified technician.

How long should I leave my Faber cooker hood running after cooking?

Leave the hood running on a low speed for approximately 10 minutes after you finish cooking. This ensures all residual odours and steam are removed from the kitchen.

What does the flashing light on my Faber cooker hood mean?

A flashing light on a Faber cooker hood typically indicates a filter maintenance alarm. A steady or slow-flashing light signals that the grease filters need cleaning (activated after approximately 100 hours of use), while a faster flash indicates the charcoal filters need replacing (activated after approximately 200 hours).

How often should I deep clean the inside of my Faber cooker hood?

Deep clean the interior of your cooker hood and the duct inside the hood once a year. This includes cleaning all accessible internal surfaces where grease may have accumulated beyond the filters.

How often should I replace the charcoal filter on my Faber cooker hood?

Standard charcoal filters should be replaced approximately every 6 months. Faber's Long Lasting charcoal filters can be washed in the dishwasher every 3-4 months and reused for up to 3 years.

What noise level should I expect from a Faber cooker hood?

A comfortable cooker hood should not exceed 55 dB(A) at maximum speed during normal operation. Faber hoods are designed to minimise noise through optimised internal airflow and components. Models with brushless motors and the Eco function can operate below 40 dB(A) for continuous air circulation.