Faber Appliance Repair in Pinhoe

Why are the lights not working on my Faber cooker hood?

If the lights on your Faber cooker hood do not illuminate but the motor works, it may be a bulb, LED strip, or driver failure. Switch off at the mains before any inspection. For halogen models, you may check and replace the bulb with a matching type, avoiding direct skin contact with the new bulb. For LED models, contact a qualified technician as LED components require technical expertise to replace. Consult your instruction manual for model-specific bulb specifications.

Why does my Faber cooker hood turn off automatically after 30 minutes?

If your Faber cooker hood switches off automatically after 30 minutes, the delay function is active. This feature allows the hood to continue extracting residual cooking odours after you finish cooking, then shuts off automatically. To deactivate this function, press and hold the delay button for approximately 3 seconds according to your model's instructions. This is a programmed feature, not a malfunction.

What does a flashing LED light mean on a Faber cooker hood?

A flashing LED light on a Faber cooker hood signals that the activated charcoal filter needs replacing. This alarm appears after approximately 200 hours of operation in recirculation mode. Replace the charcoal filter with a genuine Faber replacement and clean the grease filters, then reset the alarm according to your model's instructions.

What does a steady LED light mean on a Faber cooker hood?

A steady LED light on a Faber cooker hood indicates that the metal grease filters need cleaning. This alarm activates after approximately 100 hours of operation. Remove the filters and wash them by hand or in the dishwasher, then reset the alarm by pressing and holding the reset button for 3-4 seconds until the LEDs flash three times.

What does it mean when the LED flashes twice on a Faber cooker hood?

Two LED flashes on a Faber cooker hood can indicate either that the remote control receiver has been activated, or that the activated charcoal filter alarm has been enabled. This is a confirmation signal showing the hood has registered your command.

How often should I deep clean the inside of my Faber cooker hood?

Deep clean the interior of your cooker hood and the duct inside the hood once a year. This includes cleaning all accessible internal surfaces where grease may have accumulated beyond the filters.

Why is a ducted cooker hood quieter than a recirculating one?

Ducted hoods are quieter because the extracted air passes directly through the ducting without obstruction. In recirculating hoods, the air must pass through charcoal filters in addition to grease filters, creating extra resistance that increases noise levels. This additional filtration step is why recirculating hoods tend to be louder.

What is the minimum installation height for a Faber cooker hood above an electric or induction hob?

The minimum distance between the cooker hood and an electric or induction hob is 65cm. If the hob has a larger cooking area, the hood may need to be positioned slightly higher to provide complete coverage.

Why is my Faber cooker hood not extracting air properly?

Poor extraction is most commonly caused by dirty or clogged filters. Remove and clean the metal grease filters and, for recirculating hoods, replace the charcoal filters if they have not been changed recently. Also check that any external ducting is not blocked or kinked.

Is grease on the filters a fire hazard?

Grease deposited on filters is inflammable, which is why regular maintenance is essential. Clean or replace filters according to the recommended schedule based on approximately 3 hours of daily use. Never allow excessive grease to accumulate on the filters.