Teka Appliance Repair in Newtown and St Leonard's

What does the Err7 error mean on a Teka washing machine?

The Err7 error on Teka washing machines indicates a secondary motor fault. Contact a specialist technician as the motor or motor control board may need inspection or replacement.

What does the E4 error mean on a Teka induction hob?

The E4 error on Teka induction hobs indicates a communication failure between the user interface and the induction heating element. Switch off the hob at the mains and wait 10 minutes before switching it back on. If the error persists, contact a specialist technician as the control board or wiring may need inspection.

What does the C81 error mean on a Teka induction hob?

The C81 error on Teka induction hobs indicates excessive temperature in the electronics or on the glass surface. The hob will switch off automatically as a safety measure. Allow the hob to cool down completely before attempting to use it again. Ensure adequate ventilation around and underneath the hob. If the error recurs frequently, contact a specialist technician to check the installation.

What does the E1 error mean on a Teka refrigerator?

The E1 error on Teka refrigerators indicates a defrost sensor failure. This sensor monitors the defrost cycle to prevent ice build-up on the evaporator. Contact a specialist technician as this is an internal component fault. Continued use may result in frost accumulation affecting cooling efficiency.

What does the ED error mean on a Teka dishwasher?

The ED error on Teka dishwashers indicates a communication failure between the main circuit board and the display panel. Switch off the dishwasher and unplug it from the mains. Wait a few minutes before reconnecting. If the error persists, contact a specialist technician as internal wiring or circuit boards may need inspection or replacement.

Which detergent compartment should I use in my Teka washing machine?

Most washing machines have three compartments marked I, II, and *. Compartment I is for pre-wash detergent, compartment II is for the main wash cycle, and * is for fabric softener. Compartment II is used most frequently.

Why won't my Teka gas hob burner stay lit?

If the burner ignites but won't stay lit, the thermocouple may be dirty or misaligned. Clean the area around the ignitor and flame failure device with a small brush and ensure they are dry. Check that the burner caps are correctly positioned. If the problem persists after cleaning, the thermocouple may need to be inspected by a specialist technician.

Why won't my Teka washing machine door open after the cycle?

The door has a safety lock that remains engaged for approximately 2 minutes after the cycle completes. Wait for the lock to release before attempting to open the door. If the door still won't open, check if there is water remaining in the drum, as the door will not unlock until the water drains. Try running a drain or spin cycle. You can also try unplugging the machine for 20-30 minutes to reset the electronic lock.

When should I replace the carbon filter on my Teka cooker hood?

Carbon filters last between three and six months depending on usage conditions. The activated carbon filter cannot be washed or regenerated and must be replaced when exhausted.

How do I clean the metal filters on my Teka cooker hood?

Release the anchoring points to withdraw the filters. Clean them by soaking in hot water with neutral detergent until the fat dissolves, then rinse under the tap. Alternatively, they can be washed in a dishwasher.