Teka Appliance Repair in St David's

What does the C81 error mean on a Teka induction hob?

The C81 error on Teka induction hobs indicates excessive temperature in the electronics or on the glass surface. The hob will switch off automatically as a safety measure. Allow the hob to cool down completely before attempting to use it again. Ensure adequate ventilation around and underneath the hob. If the error recurs frequently, contact a specialist technician to check the installation.

What does the E3 error mean on a Teka refrigerator?

The E3 error on Teka refrigerators indicates a problem with the refrigerator compartment temperature sensor. This sensor monitors the temperature in the main fridge section. Contact a specialist technician as the sensor may need inspection and replacement. Temperature regulation in the refrigerator section may be affected until repaired.

What does the Err6 error mean on a Teka washing machine?

The Err6 error on Teka washing machines indicates a motor error. Contact a specialist technician immediately and do not attempt to use the machine until the motor has been inspected.

What does the UNB error mean on a Teka washing machine?

The UNB error on Teka washing machines indicates an unbalanced load where the spin cycle has failed due to uneven distribution of laundry in the drum. Open the door and redistribute the laundry evenly around the drum. Reduce the load size if it is too large and restart the spin cycle. If the problem persists with balanced loads, contact a specialist technician.

What does the E4 error mean on a Teka induction hob?

The E4 error on Teka induction hobs indicates a communication failure between the user interface and the induction heating element. Switch off the hob at the mains and wait 10 minutes before switching it back on. If the error persists, contact a specialist technician as the control board or wiring may need inspection.

Why won't my Teka gas hob burner stay lit?

If the burner ignites but won't stay lit, the thermocouple may be dirty or misaligned. Clean the area around the ignitor and flame failure device with a small brush and ensure they are dry. Check that the burner caps are correctly positioned. If the problem persists after cleaning, the thermocouple may need to be inspected by a specialist technician.

How should I clean my Teka oven if it doesn't have pyrolytic cleaning?

After cooking, wipe the oven interior with a damp cloth while still warm to prevent buildup before it hardens. For deeper cleaning, mix 4 tablespoons of baking soda with water to make a paste, spread it on dirty areas, and leave for a few hours or overnight before wiping clean.

Why is there excessive foam inside my Teka dishwasher after a wash?

Excessive foam is usually caused by using too much detergent or using the wrong type of detergent. Only use detergents specifically designed for automatic dishwashers.

Which detergent compartment should I use in my Teka washing machine?

Most washing machines have three compartments marked I, II, and *. Compartment I is for pre-wash detergent, compartment II is for the main wash cycle, and * is for fabric softener. Compartment II is used most frequently.

How do I clean the metal filters on my Teka cooker hood?

Release the anchoring points to withdraw the filters. Clean them by soaking in hot water with neutral detergent until the fat dissolves, then rinse under the tap. Alternatively, they can be washed in a dishwasher.