AEG Appliance Repair in Exwick

What does error code E6 or E641 mean on an AEG hob?

Error codes E6 or E641 on an AEG hob indicate insufficient power - the hob is connected to only one phase. This often occurs with incorrect installation. Have a qualified electrician check the connection meets the requirements in the installation instructions.

What does error code i40, i43 or i44 mean on an AEG dishwasher?

Error codes i40, i43 or i44 on an AEG dishwasher indicate a pressure sensor or water level problem. Unplug for 5 minutes then reconnect. Check and clean all filters and clear any foam from the sump. If the problem persists, contact a qualified technician.

What does error code E50 mean on an AEG tumble dryer?

Error code E50 on an AEG tumble dryer indicates a motor or software problem. Unplug the dryer for 30 seconds, then plug it back in and select a programme. If the error reappears, contact a qualified technician.

What does error code E08 mean on an AEG fridge freezer?

Error code E08 on an AEG fridge freezer indicates a low voltage warning - the power supply has dropped below 170V. This is a protective warning to prevent compressor damage. Check your home's electrical supply is stable. If the warning persists, contact a qualified electrician.

What does error code i50 mean on an AEG dishwasher?

Error code i50 on an AEG dishwasher indicates a wash motor or pump malfunction. Switch off at the mains for 5 minutes then switch back on and test. If the error persists, contact a qualified technician.

How do I clean the heat exchanger on my AEG washer dryer?

Switch off and unplug the machine before cleaning. Locate the heat exchanger access panel at the front bottom of the machine. Open the cover, remove any visible lint or debris, and use a vacuum cleaner with a brush attachment to clean the fins. Clean at least once a month for optimal drying performance.

Where can I find the model and serial number on my AEG appliance?

The rating plate with model (PNC) and serial number is typically located: on washing machines and dryers, inside the door frame; on dishwashers, inside the door edge; on fridges and freezers, inside on the left wall; on ovens, behind the door on the frame; on hobs, on the underside. You will need these numbers when ordering spare parts or booking repairs.

Can I connect my AEG washing machine to a hot water supply?

AEG does not recommend installation using a hot water connection. While inlet valves can technically handle water up to 65°C, washing programmes don't use hot water constantly, and constant hot water supply produces poor washing results.

Why are my clothes still damp after using my AEG washer dryer?

The most common cause is overloading beyond the drying capacity. Check that your load weight matches the drying capacity, not the washing capacity. Also ensure the lint filter is clean and the condenser unit is not blocked. Clean these components regularly for optimal drying performance.

Can I wash and dry in one continuous cycle on my AEG washer dryer?

Yes, most AEG washer dryers offer a Non-Stop programme that automatically transitions from washing to drying. However, for best results with full loads, it's recommended to wash first, remove some items to match the drying capacity, then run the drying cycle separately.