AEG Appliance Repair in Pinhoe

What does error code E30 or C3 mean on an AEG washing machine?

Error codes E30 or C3 on an AEG washing machine indicate water has been detected where it should not be, typically due to a leak or pressure sensor issue. Switch off the appliance, unplug it from the mains, and turn off the water supply before any inspection. Check the water inlet hose connections at both the tap and machine, and inspect the door seal for damage. Do not use the appliance until the source of the problem is identified. If the leak source is not visible, contact a qualified technician.

What does error code E10, E11 or C1 mean on an AEG washing machine?

Error codes E10, E11 or C1 on an AEG washing machine indicate a water inlet problem - the machine is not taking in water or has not taken in enough water. Switch off the appliance and unplug it from the mains before any inspection. Check that the water tap is fully open, inspect the inlet hose for kinks or blockages, and clean the inlet hose filter. If the problem persists, contact a qualified technician.

What does error code F1 mean on an AEG oven?

Error code F1 on an AEG oven indicates a door closure problem, often related to the pyrolytic function. Check the door is intact, properly secured and fully closed. If the door was recently removed for cleaning, ensure it has been refitted correctly. If the problem persists, contact a qualified technician.

What does error code iF0 or iF1 mean on an AEG dishwasher?

Error codes iF0 or iF1 on an AEG dishwasher indicate a water level problem. Switch off the appliance before any inspection. Check the filter and sump for foam, suds and debris, and clean all filters thoroughly. If the problem persists, contact a qualified technician.

What does error code C2 mean on an AEG oven?

Error code C2 on an AEG oven indicates the food temperature probe is still connected while attempting pyrolytic cleaning. Disconnect the food sensor from its user-accessible socket (located at the top right inside the oven cavity) before running the pyrolytic function.

How do I clean mould from the door seal on my AEG washing machine?

Switch off and unplug the machine before cleaning. Clean rubber door seals using sodium carbonate crystals, thick bleach, or dishwasher cleaner to dissolve stubborn mould and soap residue. Never mix different cleaning products as this can create toxic fumes. Ensure good ventilation during cleaning. Wear rubber gloves and protective goggles.

How often should I descale my AEG washing machine?

Occasionally run a cycle with a washing machine descaling product in an empty drum to prevent limescale build-up, even if your detergent contains water-softening agents. Treat your machine with a deep clean twice a year.

How often should I descale my AEG steam oven?

Descale your steam oven when prompted by the display, typically every 15-30 uses depending on water hardness in your area. Use the AEG descaling product or citric acid solution. Run the automatic descaling programme and follow the on-screen instructions. In hard water areas, more frequent descaling may be required.

How do I drain residual water from my AEG steam oven?

Allow the oven to cool completely after use. Open the door carefully, keeping face and hands away from any residual steam. Remove the water tank and empty any remaining water. Use the provided sponge or cloth to absorb water pooled at the bottom of the cavity. Wipe the interior dry to prevent mineral deposits and odours.

How often should I clean the grease filter on my AEG cooker hood?

Clean the grease filter after approximately 40 hours of usage, or when your hood displays the letter 'F'. Switch off the cooker hood and allow filters to cool if recently used. You can wash the filter with a sponge using non-abrasive detergent, or in the dishwasher at low temperature on a short cycle.